nrf52832-mdk board corresponds to the
Makerdiary nRF52832-MDK v2 board. It
runs on an nRF52832 ARM CortexM4 microcontroller from Nordic with BLE radio
nrf52832-mdk board can reset, debug and program the ARM Cortex M4
through the embedded debugger (DapLink) connected to the gateway USB port. This
component also allows a UART connection to the M4.
IoT-LAB special configuration
The serial connection baudrate should be configured at 115200 bauds in the firmware and use UART0 on pin 19 (RX) and 20 (TX).
Schematics and Datasheets
The hardware configuration is available here.
The board is running on an nrf52832 microcontroller.